BGP Peering is not required on the Management VRF. The same management VRF can also be used by the PE router to send IP SLA probe to the SD-WAN Gateway to check for SD-WAN Gateway status (SD-WAN Gateway has stateful ICMP responder that will respond to ping only when its service is up). It is recommended that a dedicated VRF is set up on the PE router for this purpose. The IP address of the management VRF inherits the IP address configured on the SD-WAN Gateway interface in Linux.Ī management VRF is created on the SD-WAN Gateway and is used to send periodic ARP refresh to the default Gateway IP to determine the next-hop MAC. Note that the IP address of each VRF is configurable per customer. In the example featuring figure below (VRF/VLAN Hand Off to PE), we assume eth0 is the interface facing the public network (Internet) and eth1 is the interface facing the internal network (customer VRF through the PE).BGP peering configuration is managed on the VCO on a per customer/VRF basis under “Configure > Customer”.

VMware SD-WAN Gateway Network Configuration In order to make changes to location configuration, deactivate cloud-init or deactivate cloud-init network configuration component:Įcho 'network: ' > /etc/cloud//99-disable-network-config.cfg Configure Handoff Interface in Dataplane Important: when cloud-init is enabled, network configuration is regenerated on every boot.

Using procmon